Technical Information Center

WC302 Automatic Wire & Tubing Cutter

Problem Possible Cause Possible Solution
Material doesn’t feed properly Feed roller not adjusted correctly Tighten the roller feed adjusting knob clockwise to increase tension (Do not over tighten, this will cause material to jam)
Feed roller tension loss Tighten the set screw on the tension block. Adjusting knob should turn with some friction
Display not functioning Blown fuse Replace with recommended fuse
Unit not powered up Turn power switch on, in the rear of the unit
Incorrect voltage supplied Make certain the incoming voltage is correct and is NOT being influenced by large equipment upstream.
Poor quality of cut or no cut Dull or chipped blades Dull or chipped blades must be replaced.
Cutting Bushing worn Rotate Cutting Bushing
Gap between blade and cutting bushing Loosen the cutting bushing set screw and slightly press the bushing to the blade, tighten the set screw
Erratic cut lengths Uneven Dereeler tension Use a power assisted dereeler at higher speeds
Feed roller not adjusted correctly Tighten the feed roller adjusting knob clockwise to increase tension, counter clockwise to reduce tension
Bushing is incorrect diameter Purchase a correct diameter bushing
Resources
WC302 Product Page
Download Operating Manual
Technical Documentation: WC302 Automatic Wire & Tubing Cutter

Can’t find your answer above?

* Required Fields
Technical Assistance

© Copyright 2024 ∙ The Eraser Company, IncFAQ'sPrivacy Statement