Material will not track through straightening rollers

Check that the indexable guide is set to the correct hold size for the material to be straightened.

Check that the material is being fed through in the proper direction.

Check that the roller assemblies have been closed down onto the material.

Check that the adjustment knobs have been locked into place.

Material is difficult to pull through unit

Check that the roller assemblies are not adjusted too tightly on material.

Check that indexable guide is set to the correct hole size for material.

Check that there are no kinks in the material being straightened.

Material does not straighten

Check that the roller assemblies are in contact with the material.

Check that there are no kinks in the material being straightened.

Resources

WS1 Product Page

Download Operating Manual

Can’t find your answer above?

* Required Fields