| PROBLEM |
PROBABLE CAUSE |
POSSIBLE SOLUTION |
| Display not functioning |
Blown fuses |
Replace with recommended fuses |
| Unit not plugged in or powered up |
Plug in unit and turn power switch on |
| Incorrect voltage supplied |
Make certain the incoming voltage is correct |
| Blade stuck in the closed position |
Blade hitting a bushing |
Reinstall bushings |
| Material doesn’t feed properly |
Belt feed not adjusted correctly |
Tighten the belt feed adjusting knob clockwise to increase tension |
| Bushings too small for material |
Reinstall proper sized bushings |
| Poor quality of cut or no cut |
Dull or chipped blades |
Dull or chipped blades must be replaced |
| Bushings not installed correctly |
Reinstall bushings |
| Incorrect rotary cutter head speed |
Readjust cut rate and/or cut time |
| No air supply to guillotine cutter |
Connect 90 psi air supply |
| Low air supply to guillotine cutter |
Connect 90 psi air supply |
| Erratic cut lengths |
Material is not feeding properly |
Make sure dereeler is used or material is unobstructed and feeding freely |
| Feed belts not adjusted correctly |
Tighten the feed belt adjusting knob clockwise to increase tension |
| Bushings too small for material |
Reinstall proper sized bushings |
| Uneven de-reeler tension |
Adjust tension if possible or use a power assisted de-reeler |
| Machine stops processing material |
Machine is out of material |
Check for error and load new length of material |
| Door is open |
Check for error and close applicable door |
| Emergency Stop button actuated |
Turn clockwise to release |
| Loss of power |
Check plug or power connection |
| Module not making good connection |
Check module alignment and mechanical/electrical connections |
| Downstream Endcap not installed properly |
Ensure downstream Endcap is installed and making solid connection |
